-
Turn off water supply to the
tap and open the tap to drain off water in pipes.
-
Remove the tap handle cap (usually marked hot or cold) to get to the tap handle fixing screw. Safely store the cap.
-
Some caps require levering out.
-
Other caps require unscrewing.
-
Remove the tap handle fixing
screw and the tap handle. Safely store the screw and handle.
-
Remove the tap bonnet (if fitted) from over the tap headgear nut. Safely store the bonnet.
-
We recommend using a rubber strap wrench to prevent damage to the tap finish.
-
The tap headgear nut must be unscrewed in an anticlockwise direction access the tap washer.
-
Select the
PoziBite insert and screw the cap screw into place
-
Put the small
toothed 'dog bit', teeth facing inward, into the the cut out in the
PoziBite and place the PoziBite over the tap head nut.
-
Use a hexagon
key to screw the cap screw tightly into the tap head nut, forcing the
pointed cap screw at least 1.5mm into the brass nut. Pre-drilling in the
correct position with the correct angle will help secure the nut, but is
not essential.
-
Place splitter spanner over the insert to the left of the tap at approx 45
degrees to the
spout.
-
Place the TapTool sleeve over the spout with the slot to the right hand side of the tap.
-
If the TapTool sleeve
is loose remove it, insert wide rubber
filler and replace. If still loose, add smaller rubber insert and
replace.
-
Place the washer on the
eyebolt and screw the long nut onto the end of the eyebolt.
-
Attach
eye of the eyebolt over the end of the spanner and place the nut & washer
in the sleeve slot; you are now ready to undo the headgear.
-
Hold the tap splitter components steady with one
hand, and use the small spanner to screw the long nut clockwise against the sleeve.
-
The tap spanner is pulled in the direction of the spout and will “crack “ the joint.
Keep turning the small spanner to free the head nut further, allowing it to be unscrewed later with ease.
-
The force applied is indirect and guaranteed not to damage ceramics or water pipes however much is applied
when following these instructions.
-
Use a hexagon
key to remove the cap screw and replace PoziBite in the case.
-
Replace the tap
washer and tap head nut.
-
The TapTool can be used to tighten up the tap head by placing the components on the other (right hand) side of the tap, again with no danger of damage to ceramics or water pipes.
Use the normal inserts, not the PoziBite insert.
-
Reassemble the tap in reverse order and turn the water back on.
